WatchGuard firewall must be running Firmware version 12.1.x or higher.  Earlier versions do not support multicast.  In "Fireware Policy Manager", create policy rules to open the following ports:

Additionally, add:

8125                     UDP                         PC to Airtame                 Device Management

Fireware Policy Manager network configuration

WatchGuard wireless setup

  1. Go to:    Network => Wireless => Configure Access Point 1 => Wireless 
  2. Uncheck: Prohibit Client to Client wireless network traffic

Enable Multicast

  1. Go to: Network => Multicast
  2. Check: “Enable Multicast Routing”
  3. Add Interfaces: – ath1 (Bridge) & Trusted_Wi-Fi
  4. Save configuration to Firebox 
Did this answer your question?