This article is for devices running version v3.0 or newer. If your TV screen indicates that Airtame's firmware version (located in the bottom right corner of the screen) is less than 3.0, please use this setup guide instead.

Download our setup manual here: 1-pager: Setup guide

Congratulations on getting your first Airtame! This guide will show you how to physically install the device, set it up and stream to it for the first time. The end goal is to have Airtame connected to your existing WiFi so that anybody on that WiFi network can stream, wirelessly.

☝️  Click here to set up using an ethernet adapter.
Note, that at the moment you cannot set up or configure Airtame using a phone or
Chromebook, as their app version does not offer access to the Device Management Panel. 

Step 1: Installing & Powering Airtame

Airtame requires 5V-1Amp of power from a USB. This USB can be the power adapter provided in the box or from your TV/Projector if it outputs 1 Amp. Your TV/projector’s USB port will be labeled “5V 1A” or “USB-HDD”. (If it says “service,” however, this will not work)

👇  Use the provided HDMI extension cord to fit Airtame in tight spots or to get the Airtame closer to the edge of the screen for better WiFi signal strength. 

Step 2: Configuring Airtame

Turn the TV on to the correct HDMI source and you will be asked to Download and install the Airtame app

The Setup Guide

The Airtame app will detect new devices when they are nearby and allow you to set them up with just a few clicks. Settings are sent through WiFi so your computer will temporarily switch to Airtame's WiFi to transfer these initial configurations.

  1. Open the Airtame app.
  2. Wait until you see the blue "Set up" button appear next to your new Airtame's name.
  3. Click "Set Up".
  4. Enter a name for your Airtame.
  5. Chose how you will connect the Airtame to your network. (WiFi, Ethernet, or Skip).
  6. If WiFi, select your network from the list of nearby WiFi's and chose 5GHz over 2.4GHz whenever available. 
  7. Click "Connect" and enter your computer's user password to allow Airtame to switch WiFis for transferring settings.
  8. Wait for confirmation to shown on the TV screen.
    ☝️
    To further configure, go to the Device Management Panel
  9. For ethernet setups, you must name the ethernet connection the SSID it is connected to: Customise Airtame's home screen text.

Step 3: Streaming

Now that the device is set up, go ahead and make your first stream:

  1. Open the Airtame app.
  2. Find your device in the list or enter its IP address.
  3. Click "Share screen" for each device you wish to stream to.
  4. When you are done, return to the app and click "Stop" to finish the stream.

 
Want to stream from a mobile device?

 

Step 4: Customizing

You can continue customizing your device by going to Airtame device settings

  1. Check for updates!
  2. Set a custom background
  3. Configure Airtame's own WiFi
  4. Reset to factory settings

 

👉 Learn more

Did this answer your question?